Skip to main content
This guide provides step-by-step instructions on how to change the window regulator on a 9th generation Honda Civic. 

Table of Contents

What you will need


  1. Open the door, turn on the ignition, and move the window all the way window regulator motor replacement open door
  2. Next, remove the key from the ignition. Pull the hood release under the dash and disconnect the negative battery terminal.disconnect the battery
  3. Remove the screw that is behind the door pull. On newer models, there is a small cover that needs to be removed first, or you may have to pop out the window switch first.
  4. Pull out the door handle. Pry out the plastic cover. Remove the Philips screw. On some models, you will have to remove the window switch first to access the panel screw. Pop out the window switch using a flathead screwdriver or dash removal door panel removal
  5. Unplug the electrical connectors. honda remove door panel driver passenger left right
  6. Remove the plastic triangle by the side mirror. In some models, such as this 9th generation Honda Civic you do not have a plastic triangle.
  7. Use a trim removal tool to pry out the door panel at the lower corners. Lift the door panel and remove it. Be careful when using a flat screwdriver for this step, as it can scratch the door. remove honda door panel
  8. Remove the plastic liner (weather seal) from the door frame. Be careful not to damage it, as you will need to reuse door regulator motor
  9. Have a helper keep the window glass up as you proceed to remove the window regulator. 
  10. Loosen two bolts that secure the glass to the window regulator. If your window is all the way up, you should see these two bolts through the access holes. If not, lower the window carefully until you see the two bolts. Reconnect the battery for a few minutes to complete this step and disconnect it again. You will see the glass secured to the window regulator with two brackets. honda window regulator exposed
  11. Next, remove all 10mm bolts that secure the Honda window regulator and motor to the window motor regulator bolts
  12. Unplug the electrical connector from the window motor first by pressing on the connector tab then pulling it.disconnect honda window motor
  13. Replace the window motor. There are three Torx screws that secure the motor to the regulator. If your Honda window regulator came with a new motor, skip this step.remove honda window motor from window regulator
  14. Reinstall in reverse order. Use a torque wrench to torque bolts that secure the glass to the regulator at 8 Nm.
  15. Operate the window several times before you close the door. Make sure it operates smoothly and that the auto-up and auto-down functions work as they should. Make sure to connect the airbag wires. Reconnect the battery and check window operation.bad honda window regulator motor

The documentation on this page will help you change the window regulator motor on Honda vehicles. If your Honda driver or passenger window no longer moves up and down, there is a good chance that the window regulator or the window motor is defective. These parts can be purchased online (they usually come as one) and replaced with only a few basic tools.


Here are some common problems that indicate that you may need to replace your Honda window regulator, window motor, or both.

  • Honda window won't go up or down.
  • Honda Accord window may get stuck in the down position.
  • Honda window glass may have come off the track.
  • You hear grinding noise from the door when trying to move the window.

Even though the pictures and videos found here are from a 2015 Honda Civic, the instructions will help you change the window motor and regulator on Honda Accord, Odyessy, CR-V, Insight, Clarity, Fit, HR-V, Passport, Ridgeline, and Pilot as they all use a similar setup.

Always Disconnect the Battery.

On some models, you may need to disconnect the side airbag. If you have to turn on the ignition or move the window up and down, make sure to reconnect the wire for the side airbag, or you will trigger the airbag / SRS light.

If you accidentally trigger the SRS light, you will need to use a scanner such as Launch Creader VII+ to reset the light.


Why won't my Honda window go up?

Can be a number of reasons such as bad window switch, bad window regulator, window motor, fuses, wiring, etc.

Can I change just my Honda window motor and reuse the regulator?

Yes. As long as the window regulator is still functional. You may want to lubricate the old Honda window regulator if you plan on reusing it.

My Honda window is stuck down. Is it a bad window regulator motor?

If you hear noise from the window when you try to move it up and down, the problem is often the regulator. If you near no noise at all, you may have a bad window motor, blown fuse, bad relay, bad window switch.

Honda Civic Window Regulator and Motor Replacement Guide This guide provides step-by-step instructions on how to change the window regulator on a 9th generation Honda Civic.