Ford Fusion Window Regulator Replacement Guide

Is the window regulator of your Ford Fusion broken? By following the procedures below, you will learn how to replace the window regulator and motor on a Ford Fusion. This guide will show step-by-step procedures for replacing your Ford’s window regulator and motor.

What you will need

Bestseller No. 1

A-Premium Electric Power Window Regulator Without Motor Compatible with Ford Fusion 2006-2012…

【Directly Fit】OE Replacement Power Window Regulator without Motor, Directly Fit; 【Position】Front Left (Front Driver Side)

$41.99

Bestseller No. 1

Dorman 740-140 Front Driver Side Window Regulator Compatible with Select Ford / Lincoln / Mercury…

Engineered improvements enhance performance; Quality tested to ensure trouble free installation, performance, and durability

$38.95

• Ford Fusion Window Regulator Motor
• Ford Fusion Window Regulator
• Prying tool
• Pick tool
• Mechanic Toolset
  • 10mm socket
  • T30 Torx bit socket

Procedure

Remove the door panel. If you need help with this step, follow these procedures for removing the door panel.

Remove the window. If you need help with this step, follow these procedures for the window removal process.

Remove the cover of the window regulator motor by pulling it out using prying or pick tool.

Disconnect the motor’s electrical connector by pressing the clip and pulling the connector out.

Remove the five 10mm bolts holding the door panel using a 10mm nut driver or a 10mm socket and twist it counterclockwise to loosen.

Reach inside the door and carry the window regulator and the motor out of the vehicle.

Remove the three T30 bolts and pull the motor out of the window regulator to replace the motor. Use a T30 Torx bit socket to remove the bolts.

Line up the new motor to the window regulator and reinstall the three T30 bolts.

Install the window regulator and motor to the door. Place the piece inside the door and line it up to its proper position.

Reinstall the five 10mm bolts holding the whole window regulator piece. Twist the bolts clockwise to tighten.

Reconnect the electrical connector of the motor by pushing the connector into the motor.

Line up the cover of the window regulator motor and press it in until it snaps into place.

Reinstall the window. If you need help with this step, follow these procedures for the window installation process.

Reinstall the door panel. If you need help with this step, follow these procedures for installing the door panel.

We hope you find the Ford Fusion Window Regulator Replacement Guide helpful. Check these troubleshooting and repair guides for more help on your Ford.