Ford Fusion Door Window Glass Replacement Guide
Reviewed/Verified by:
Is the window of your Ford Fusion’s door broken? By following the procedures below, learn how to replace the door window on a Ford Fusion 2013 to 2020.
At a Glance
- Fits: 2013 to 2020 Ford Fusion front door
- Tools: T handle Allen wrench, 7mm nut driver, trim tools
- Access: remove the door panel and speaker, then lower the window to reach the clips
- Clean up: remove all broken glass from the door first
- After: reset the auto up and down function
Before You Start
- Broken glass: vacuum all glass from inside the door and the window channels before installing the new glass; leftover pieces can jam the regulator.
- Window off its track but not broken: the regulator or its glass clips may have failed rather than the glass.
- Wear gloves and eye protection when handling broken tempered glass.
- After install: run the window fully down and up, holding the switch a few seconds at each end to reset the one touch function.
What you will need
- Ford Fusion Door Window
- T-Handle Allen Wrench
- Silicone Glue
- 7mm Nut Driver
Procedure
Remove the door panel. If you need help with this step, follow these procedures for removing the door panel.
Remove the plastic cover on the door by pulling it out.
Disconnect the speaker’s electrical connector by pressing the clip and pulling the connector out.
Remove the three 7mm bolts on the speaker by twisting it counterclockwise using a 7mm nut. Then, pull the speaker out of the door.
🔧 Find out what is actually wrong before you pay someone to guess
Dealer level diagnostics at home with the YOUCANIC UCAN-II Pro.
- ✔ Covers most makes and models, including many luxury brands. Send us your VIN and we will confirm your car before you order
- ✔ Reads every module, not just the engine, so you find the faults a basic reader says are not there
- ✔ Commands the car: test a fan or pump, bleed ABS, retract an electronic parking brake, register a battery
- ✔ No subscriptions. Free lifetime updates, so the price you pay is the whole price
- ✔ Backed by real mechanics in the USA you can email before and after you buy
Featured in The Wall Street Journal
Connect the window switch and move the window 6 inches to access the clips holding the window.
Locate the clips on the window regulator arm and the speaker’s area.
Detach the clips by pushing them using a T-Handle Allen wrench.
Pull the window up and bring it to an angle where it can be removed from the door.
Carry the new window and bring the window to an angle to where it can be easily slid into the door. 
Turn the window to its proper orientation and push it down until it snaps into place. The snap sound will indicate that the clips are attached or locked into the window.
Line up the speaker to the door and reinstall the three 7mm bolts. Tighten the bolts. Do not over tighten. 
Reconnect the electrical connector of the speaker by pushing the connector into the connection port.
Line up the plastic cover back to the door and press its edges to stick the glue to the door.
Reinstall the door panel. If you need help with this step, follow these procedures for installing the door panel.
Check these troubleshooting and repair guides for more help on your Ford.
Frequently Asked Questions
Can I replace a Ford Fusion door window myself?
Yes, with basic tools. Remove the door panel and speaker, release the glass from the regulator clips, and install the new glass.
Why does my Fusion window fall into the door?
The regulator or its glass clips have broken. The glass itself may be fine.
How do I reset the auto window after replacement?
Run the window fully down and hold the switch for a few seconds, then fully up and hold again.
Related Guides
- 2013 to 2020 Ford Fusion Door Panel Installation
- 2013 to 2020 Ford Fusion Door Panel Removal
- Ford Fusion Door Actuator Handle Replacement
- Open Door of a Ford Fusion with Dead Battery
