- Jump Started or Installed Battery the wrong way
Jump Started or Installed Battery the wrong way
Car owners may accidentally connect the jumper cables in reverse order or install the battery backward. The vehicle may no longer start. The purpose of this troubleshooting guide is to help answer the following questions:
- Hooked battery up backward now car won't start
- What happens when you connect a car battery the wrong way
- Car battery connected backward
- Car battery installed incorrectly
- What happens if you hook up battery cables wrong
- Accidentally installed car battery in reverse
- Hooking up battery cables backward
- Hooked battery up backward on four wheeler
Connecting the jumper cables backward or installing a new battery the wrong way is never fun. In this article, you will find troubleshooting steps that will help you diagnose such problems.
Installed new battery backward, car won't start
You decided to change the car battery but accidentally put the cables backward. Instead of connecting the positive (+) cable to the positive battery terminal, and negative (-) cable to the negative battery terminal you hooked them up backward. All of the sudden you see a scary spark and your car goes completely dead. Car will no longer start. Dashboard lights are off, and everything is dead. Key may not even turn the ignition. Similar symptoms will be experienced when you try to jump start a dead battery but you accidentally connect the jumper cables backward.
When a car battery is connected backward a fuse designed to protect vehicle electronics should blow. If your vehicle doesn't have a fuse (almost all cars do) designed for this purpose, you will send electrical current backward through systems in your car including ECU, transmission control unit and more. If current flows backward through lights that's not a problem. The issue is when current flows backward through an electronics that have diodes such as the ECU / ECM (Engine Control Unit / Module).
It is not common to damage the Engine Control Unit / Module by connecting the battery cables incorrectly. Most of them are designed to withstand reverse polarity. In the worst case, the ECU/ECM can be removed and inspected if a diode has failed.
Troubleshooting Car Won't Start Problem
Check the high ampere fuses on your car. Most vehicles have a large fuse that will blow and avoid damage to the ECU / ECM. This may be a 40, 60, 80-ampere fuse and it is usually hard to find. Here is a picture of this fuse on a Honda Civic. When the jumper cables were connected backward, this fuse blew. This is from a 2015 Honda Civic.
Embedded Video (Responsive).
Notice the fuse strip. More than one fuses can blow. Once you replace this fuse, start up the car. In most cases, the car should start right up. If it doesn't, continue to Step 2.
After you replace the blown fuse, you may still have a problem starting the engine. The engine may turn over and crank, but it will not start. Now it is time to check all the smaller fuses. Make sure that the fuse for the ignition system, ECU, fuel pump, Immobilizer are still good.
If all the fuses are still good and your car still refuses to start here are a few things you need to check.
The car turns over but won't start.
- Check if there is spark at the plugs
- Check fuel pressure
- Check if direct injectors are getting power
Car won't turn over or crank.
- Immobilizer system
- Engine Control Unit is getting power
- Check to see if the starter is getting power
Hopefully, you were able to diagnose the problem yourself. If you are still having problems with being able to start the car you may want to consider having a mechanic take a look at your car. Avoid letting water or rainfall on your fuse panel.
Do not allow water or rain on your fuse panel.